How To Install Bidet Hose
May 08, 2022 published at 2:34 AM ByEveRenonation.sg
A bidet spray, also known as health faucet, is a triggered water nozzle that is installed next to the h2o closet. It is similar to a kitchen sink spray and can be used to clean the toilet floor and wall.
The cost of supply and installation of a bidet spray in Singapore is not cheap, as it costs around $120 to $150 per toilet.
Since the installation process is fairly easy (as it only involves installing an boosted T-valve to the water valve), yous can hands install one yourself inside half an hour without the help of a plumber! In this way, you can salve around $100, since the toll of the T-valve and the bidet spray is effectually $fifty!
Tools needed
- Spanner or Wrench
- T-Valve
- Bidet Spray
- PTFE Seal Tape or Plumber's Tape
- Pair of scissors
Footstep one: Turn Off the Water Supply
Make sure that the water supply valve, located at the wall next to your water cupboard, is turned off before you first the installation.
Step two: Disconnect the Water Supply Hose from the Fill up Valve
Locate the fill up valve underneath the h2o closet. Unscrew the water supply hose with the spanner from the fill valve.
Stride iii: Connect the T-Valve to the Fill Valve
Note that the flat rubber washer should be inside the top of the T-valve.
Wrap the PTFE seal tape around the T-valve threads, located at the bottom of the T-valve. The PTFE seal tape will aid to lubricate the connection and allowing the T-valve to be screwed tighter with the water supply hose later. Spiral the acme of the T-valve onto the fill valve with the spanner.
Tip: To prevent leaks and for a tighter, h2o tight connection, wrap a few rounds of the PTFE seal record effectually the threads for all the connections. Read how to use the PTFE seal tape properly hither.
Stride 4: Connect the Water Supply Hose to the T-Valve
Screw the water supply hose to the bottom of the T-valve, which has been wrapped with the PTFE seal record.
Pace v: Connect the bidet spray to the T-valve
Connect i end of the bidet hose to the side of the T-valve. Recollect to plough on the water supply prior utilize!
Finally, check for water leaks by turning on the bidet spray!
[embed]https://youtu.be/R_Hi-MGfFG0[/embed]
Tip: To avert drilling, use drywall screws, anchors or even the heavy duty, double sided tape to attach the holster holder to the wall.
This article was first published in Renonation.
Source: https://www.asiaone.com/lifestyle/how-install-handheld-bidet-spray-5-simple-steps
Posted by: ellisoffearmed.blogspot.com
0 Response to "How To Install Bidet Hose"
Post a Comment